another rats nest removal question...
#1
Senior Member
Thread Starter
Join Date: Dec 2004
Location: Minot, ND
Posts: 345
Likes: 0
Received 0 Likes
on
0 Posts
another rats nest removal question...
Hey guys I've been searching for the last couple days, I've found the diagrams and everything I need to eliminate my rats nest and selenoids, as I'm going to a single turbo setup. However, what I haven't been able to find out is what size, and how much vacuum line do I need. I'm going to run a single, with a power fc, so I should be able to eliminate almost everything. Also where can I order silicone hoses from? I appreciate everyone's help.
#2
You will need the following:
Vacuum caps in sizes 5/32", 1/4" and 3/8"
5/16" fuel injection hose (about 5 feet)
5/32" vacuum line (about 3 feet)
Vacuum tee's and splitters
Ultra black sealant
Block off plates (RX7 store)
Vacuum caps in sizes 5/32", 1/4" and 3/8"
5/16" fuel injection hose (about 5 feet)
5/32" vacuum line (about 3 feet)
Vacuum tee's and splitters
Ultra black sealant
Block off plates (RX7 store)
#3
Senior Member
Thread Starter
Join Date: Dec 2004
Location: Minot, ND
Posts: 345
Likes: 0
Received 0 Likes
on
0 Posts
I really appreciate the help. any idea in what quantity I need the vacuum caps? and that's all the vacuum line I need, huh? seems like it would be more.
#4
I can't say exactly how many caps you'll need, I havn't finished my non-sequential mod yet. I may be going single turbo too.
You don't need much vacuum line if you plan on deleting all the solenoids. Some are for emissions stuff, you didn't say if those were going as well. If it all goes then you don't have much vacuum lines left, maybe 5 total.
You don't need much vacuum line if you plan on deleting all the solenoids. Some are for emissions stuff, you didn't say if those were going as well. If it all goes then you don't have much vacuum lines left, maybe 5 total.
Thread
Thread Starter
Forum
Replies
Last Post