20B Single turbo options
#1
Rotary Enthusiast
Thread Starter
20B Single turbo options
Hi Guy's I have posted in the 20B section as well as I wasn't sure where I would get the most reads and feedback! Just starting to round up bits for my 20B project and wondering what would be a good turbo option. it will be a road car mainly so want to keep lag to a minimum. Aiming for somewhere in the 600bhp flywheel bracket. probably running 1 around 1.0bar boost if that adds up.
I was thinking after my Holset Success on my 13B I would go this route again even if it is a large unit to package. I was thinking a HX50 should do the job? can someone let me know thoughts on this and a suitable exhaust housing size to go for?
Other option I might look at would be Master Power unless people say not.. I have quite fancied trying one of their units and heard good things from a few people over here?
Thanks in advance
Lee
I was thinking after my Holset Success on my 13B I would go this route again even if it is a large unit to package. I was thinking a HX50 should do the job? can someone let me know thoughts on this and a suitable exhaust housing size to go for?
Other option I might look at would be Master Power unless people say not.. I have quite fancied trying one of their units and heard good things from a few people over here?
Thanks in advance
Lee
Thread
Thread Starter
Forum
Replies
Last Post
stickmantijuana
3rd Generation Specific (1993-2002)
5
01-11-16 04:08 PM
stickmantijuana
Single Turbo RX-7's
0
08-21-15 08:35 PM