Adaptronic Modular FD3S S6 & S7/S8 Plug and Play ecus are now available! We have 5 ecus being assembled and shipping to us next week. We are including a free remote tuning session with each one of these first units. These units have been fully tested on multiple vehicles, including 2 different single turbo FD3S Rx7s. The full production batch will start in a couple weeks.

Blog post regarding the technical aspecs of the new ecu;

https://blog.turbosource.com/2016/03...gement-system/

Purchasing;

http://www.turbosource.com/Adaptroni...s-amrx7pnp.htm


​​​​​​

 

Purchasing link isn't working for me

 

Fixed!

 

We also have a small batch of M2000 ecus coming in, these are available with pins/connectors or a mil spec flying short or long lead harness. We make those harnesses in house.

 

I'm looking at upgrading from my PFC/Datalogit to this ECU over the winter and adding your WI kit at the same time.
I have a stockish car with stock sequential turbos. Fuel mods coming fairly soon.
What additional sensors, if any, do you think would be prudent to order?
I'm thinking fast-reacting air temp and maybe the 3-way BCS?

Thanks

 

The Adaptronic ait, mac valve, innovate wideband and fuel pressuere sensor would be a minimum.

 

The Adaptronic ait, mac valve, innovate wideband and fuel pressuere sensor would be a minimum.

 

2 FD pnps and 1 M2000 left in the first batch that should arrive tomorrow
​

 

1 of each left...

 

https://blog.turbosource.com/2016/11...lar-m6000-ecu/

 

They are here! Back orders are shipping now.

 

Sold out, working on an ETA for more units.

 

2 weeks before our next shipment arrives. We have already sold a few on this next order too. Chances are they will be sold out before they arrive. It would be best to order now if you want one.

 

S8 Modular PNP ECU

 

Modular s8 pnp in red vs oem ecu in blue. Back to back at same boost pressure. Much better boost control during transition.

 

S8 Modular PNP install and break in at Raceonly. Will hit the dyno soon;

https://www.facebook.com/Raceonlygarage/photos/pcb.1130191807057224/1130191637057241/?type=3&theater

 

Andy has released an rx7 specific informational video:

 

Informative video!

 

I have had my first chance to tune a modular and no issues;

Here is a video of the car;

https://www.instagram.com/p/BNe4UR6j...en-by=turblown

A screen shot and some information on how the new software makes tuning even easier;

https://www.instagram.com/p/BNhnrq_j...en-by=turblown

I have this car street tuned to 17 psi with no issues.

 

Modular FD pnp dyno.

 

I have put some snippets up from the PRI show on the new fuel model in Modular units. We have some editing to do for the long youtube versions :

https://www.instagram.com/p/BN2b8d-AWDW/

 

20B installation using a PNP Modular ecu. You can use the FD PNP with some harness mods( for 3rd rotor fuel/ingition) if using 2 injectors per rotor. M2000 wire in also works in the same fashion. M6000 wire in should be used if doing 3 or more injectors per rotor;