I actually need to get some pipes bent for my 6 and not my 7... 1980 BMW 635CSi. It's over 25 years old and since it's also a Euro spec model is cat exempt anyway. I basically need a downpipe from the manifolds and a muffler that ends in the middle of the car where a cat would normally be. This will save weight and of course is cheaper for me. I'm guessing a normal exhaust shop will try to sell me into buying a cat and or full exhaust...I don't want the hassle. Does anyone know of a performance shop here in Atlanta that will give me what I want? Thanks

 

Yes, contact turbo performance systems in Acworth. They are a small homegrown operation but do a good job. http://www.boostedsystems.com for contact info.

They start out by piece-welding a very workable exhaust, and then if you like it they can get that made in usually one-piece mandrel-bent stainless or regular steel at a really good price. I'm actually still running the piece-welded exhaust.

Joe is the guy to talk to, tell him Daniel with the turbo convertible RX-7 sent you and he might be even nicer than his normal nice self.

 

How much did they charge you for your exhaust?

 

place is right down the street from me..pretty sure its on lake acworth drive next to the citgo/liquor store

 

Don't remember. It was very reasonable tho. I think around $100 including material and labor for two custom midpipes (one with cat, one without), modify an aftermarket catback to a ball joint (gasket-less) fitting to the midpipe (for quicker change), and some other misc. turbo stuff I bought from them. But don't quote me on that, and they did give me a bit of a friends discount.

 

Grand Muffler in Symrna has good prices and good work!