Rtek Map sensor upgrade?
#3
Senior Member
i'm still 1.8 so not 100% sure this can be done:
if not willing to divorce the Rtek7, an approach to consider in the meantime would be to install a 2 bar supplemental fuel setup to come on at your desired boost point from where the Rtek7's boost refrenced pulse width goes flat. like if having an FCD installed. but you still have the ability to trim based on RPM.
you already have injectors. just a matter of locating the controller and welding the injector bosses to the pipes.
i have an HKS unit that i keep around incase i decide 1 day to control H2O/meth injection.
if not willing to divorce the Rtek7, an approach to consider in the meantime would be to install a 2 bar supplemental fuel setup to come on at your desired boost point from where the Rtek7's boost refrenced pulse width goes flat. like if having an FCD installed. but you still have the ability to trim based on RPM.
you already have injectors. just a matter of locating the controller and welding the injector bosses to the pipes.
i have an HKS unit that i keep around incase i decide 1 day to control H2O/meth injection.
Thread
Thread Starter
Forum
Replies
Last Post
mulcryant
2nd Generation Specific (1986-1992)
10
09-09-15 05:24 PM