showed knock; 104,, how bad is this???
#1
Rotary Enthusiast
Thread Starter
Join Date: Mar 2002
Location: Tuscaloosa, AL
Posts: 1,430
Likes: 0
Received 0 Likes
on
0 Posts
showed knock; 104,, how bad is this???
I noticed on my commander that I hit 104 on my knock level.. Im usually around 80-90 but earlier today I hit 104 .. Can somebody tell me how bad this is???
#4
Ghost Ride the Whip
Koji from XS engineering told me that it's generally bad to have anything over 70 on the knock reading. However, I have been told that the power FC readings from the commander are very inaccurate.
Rotary's consume oil when driven. It just depends on how much oil you are consuming that matters. Mazda says that 1 quart of oil for 1000 miles is ok. How many miles are on your existing motor and what mods do you have??
Rotary's consume oil when driven. It just depends on how much oil you are consuming that matters. Mazda says that 1 quart of oil for 1000 miles is ok. How many miles are on your existing motor and what mods do you have??
#6
Senior Member
iTrader: (4)
Join Date: Jul 2001
Location: long beach, ca
Posts: 363
Likes: 0
Received 0 Likes
on
0 Posts
i got 130 once. after i install my hks twin power. before that it was at 60 and under. try adding fuel. it help me.
before i had the hks twin power my knock go up when i down shift braking. so i rise up the decelration fuel and it help alot.
-andrew-
before i had the hks twin power my knock go up when i down shift braking. so i rise up the decelration fuel and it help alot.
-andrew-
Thread
Thread Starter
Forum
Replies
Last Post
rgordon1979
3rd Generation Specific (1993-2002)
40
03-15-22 12:04 PM
Jeff20B
1st Generation Specific (1979-1985)
73
09-16-18 07:16 PM
The1Sun
1st Generation Specific (1979-1985)
0
09-07-15 10:21 PM
83revival
New Member RX-7 Technical
4
09-03-15 10:42 PM