measurement on water seal groove 13bt
#1
Full Member
Thread Starter
Join Date: Jul 2006
Location: Norway
Posts: 91
Likes: 0
Received 0 Likes
on
0 Posts
measurement on water seal groove 13bt
hello!
I have just pulled a 13bt engine, and the wear on the iron was bad. have measured up to 0.3mm wear.
sooo i need to machine them, but i dont know if thet have been done before, so need the orginal depth of the water seal groove to figure it out!
anybody know?
regards,stig
I have just pulled a 13bt engine, and the wear on the iron was bad. have measured up to 0.3mm wear.
sooo i need to machine them, but i dont know if thet have been done before, so need the orginal depth of the water seal groove to figure it out!
anybody know?
regards,stig
Thread
Thread Starter
Forum
Replies
Last Post
Jeff20B
1st Generation Specific (1979-1985)
73
09-16-18 07:16 PM
msilvia
3rd Generation Specific (1993-2002)
15
09-11-15 12:13 PM