MAP sensor/ haltech/ custom manifold
Thread Starter
Senior Member
Joined: Oct 2003
Posts: 732
Likes: 0
From: idaho
MAP sensor/ haltech/ custom manifold
I'm planning on building a 13b pp with a haltech e6k and custom intake runners, intake plenum, and throttle bodies. I was just wondering where the MAP sensor would go.
Rotary Enthusiast
Joined: Oct 2002
Posts: 1,165
Likes: 0
From: California, Bay Area
Im no expert, but i think you would have to run a vac line from each runner placed somewhere between the butterfly valves and the motor going into into a T fitting and then into the MAP sensor.
