Machined Rotors
#1
Red Pill Dealer
Thread Starter
iTrader: (10)
Machined Rotors
I posted in the second gen but thought you guys might like the pics too. I was initially after the closing chamfers that I had seen in another thread and wrongly attributed to BlueTII. I believe now it was SureShot. I think the thread was " Me and my Dremel".
I went ahead and thinned the sides for lightening. Forgive me for the surface rust. It shows up well in the pics but is very thin and comes off easy.
Tell me what you think.
I went ahead and thinned the sides for lightening. Forgive me for the surface rust. It shows up well in the pics but is very thin and comes off easy.
Tell me what you think.
#2
Red Pill Dealer
Thread Starter
iTrader: (10)
I still need to de-burr, clean all seal grooves of carbon, and polish the combustion chambers before sending out to re-balance.
#4
Red Pill Dealer
Thread Starter
iTrader: (10)
Originally Posted by diabolical1
they look great. really wish i had your equipment and skills. just curious as to 2 things. first, what time do those chamfers open the ports? how much weight does that represent?
Free mods are the best mods!
Thread
Thread Starter
Forum
Replies
Last Post
Jeff20B
1st Generation Specific (1979-1985)
73
09-16-18 07:16 PM