48 Ida
#2
do a google search for Air Cooled Engineering (ACE) they are big time weber gurus and WILL have some. You need to be very careful when installed those. You should be able to hold the carb up to light and see a ring of light all the way around the butterflys. If you cant, then the blades are touching the aluminum. if this is the case, then they will wear at the sides of the body and eventauall youll have to spend about 2-300 bux to have it bored to the next size and replace both blades. It can take experienced guy 20-30 minutes to index the blades so that they dont touch. be careful and tke your time, tightening and loosening the throttle shaft nuts will pull the shaft either way and can cause rubbing also. good luck.
CJG
CJG
Thread
Thread Starter
Forum
Replies
Last Post