fd vs. 450whp ss and 06 viper... vids.
08-15-09, 04:40 PM
#1
fd vs. 450whp ss and 06 viper... vids.
some new runs i have done in my fd, first was an 06 viper. we did a quick pull on a 2 lane main road but had a good amount of room. he was behind me so technically i started a car ahead. but i did not brake boost. we did a 40-100 run and i put close to 4 cars on him before i started stoping. we pulled up at the next light and he was pretty impressed at how fast it was. he said i was just running away from him and he did not expect that. it was a stock 2006 viper srt 10.
next run later on in the day was between me and a buddy who has done several mods since we ran last. he has a 2001 camaro ss with 11.8 compression, afr milled heads. ms3 cam , cut out exhaust etc... he makes slightly over 450whp n/a. car runs very strong. he runs close to 125 mph in the quarter. i have recently raised my boost to 18psi and set up an agressive timing map which bdc and chuck westbrook helped me with. the car has much more torque in the 5k range. here are the 3 runs we did. i put a consistant 2-3 cars on him by 140. the race to 110 i spun through 2nd and started to pull away in 3rd before we let out.
also the camera car was a 430whp paxton charged 5.0
60-140mph run
http://www.youtube.com/watch?v=aECRZRmcQ68
60-140mph run 2.
http://www.youtube.com/watch?v=neyPKY7sisk
50-110mph run
http://www.youtube.com/watch?v=WGUEzXMclts
next run later on in the day was between me and a buddy who has done several mods since we ran last. he has a 2001 camaro ss with 11.8 compression, afr milled heads. ms3 cam , cut out exhaust etc... he makes slightly over 450whp n/a. car runs very strong. he runs close to 125 mph in the quarter. i have recently raised my boost to 18psi and set up an agressive timing map which bdc and chuck westbrook helped me with. the car has much more torque in the 5k range. here are the 3 runs we did. i put a consistant 2-3 cars on him by 140. the race to 110 i spun through 2nd and started to pull away in 3rd before we let out.
also the camera car was a 430whp paxton charged 5.0
60-140mph run
http://www.youtube.com/watch?v=aECRZRmcQ68
60-140mph run 2.
http://www.youtube.com/watch?v=neyPKY7sisk
50-110mph run
http://www.youtube.com/watch?v=WGUEzXMclts
08-15-09, 07:12 PM
#4
thanks all.
hey 1quik, im at just about 7700 at 140mph in 4th gear. i also changed my tranny to a jspec 96+ since they have a .806 5th gear. so now it continues to pull very well in 5th. it tops out sooner at 180mph but gets there much faster.
hey 1quik, im at just about 7700 at 140mph in 4th gear. i also changed my tranny to a jspec 96+ since they have a .806 5th gear. so now it continues to pull very well in 5th. it tops out sooner at 180mph but gets there much faster.
Trending Topics
08-19-09, 07:32 AM
#13
montego, i was at 18psi with agressive timing. on 16psi with pump gas timing it would be much closer i would be right there with the viper and camaro. how is your setup running? i actually made close to 430whp with the setup i sold you at 16psi. so it seems to flow better then my current kit. it is most likely the vented wastegate.
08-19-09, 08:47 PM
#15
i will get the dyno graph of my 16psi pump gas setup. the dyno around here seems to read a little on the low side. it is a dynojet as well. i should be dynoing the car this sat with the current setup. i street tune now and it seems to work out much better since it is ambient real conditions. i use the performance vbox to measure gains. i went from 8.89 seconds 60-130mph with the pump gas setup down to 7.96 seconds at 18psi. it should be around around a 130mph 1/4 mile setup. i still plan on running a bit more boost i just need more fuel now.
08-19-09, 10:51 PM
#20
also forgot to add the mods list to the camaro. he is going to dyno again on a dynojet. his current numbers were off a mustang dyno.
built ls1 with mahle 4cc pistons 11.8 cr
afr 205cc heads milled to 59cc
1 3/4" long tubes
4" cut out exhaust at mid
fast 92/92
roller rockers
g5x3 cam
electric water pump
4.10 gears
built ls1 with mahle 4cc pistons 11.8 cr
afr 205cc heads milled to 59cc
1 3/4" long tubes
4" cut out exhaust at mid
fast 92/92
roller rockers
g5x3 cam
electric water pump
4.10 gears
. Always a pleasure to chill & watch some youtube 7kills
08-20-09, 10:17 AM
#25
Senior Member
iTrader: (4)
Join Date: Jun 2006
Location: Miami, Florida
Posts: 618
Likes: 0
Received 0 Likes
on
0 Posts
****** sweet kills.. I can't wait till mine is out of the shop and broken in already.. Almost got a boner I thought u were posting a vid for the run against the viper lol. Rage ur avatar is ******* win bro