having rearend trouble
#1
Newbie
Thread Starter
Join Date: Aug 2006
Location: alabama
Posts: 1
Likes: 0
Received 0 Likes
on
0 Posts
having rearend trouble
I am breaking ring n pinion gears when i launch I am running 26-10.50 slicks i have tried running drag radials but i do nothing but spin out of the hole i have tried ajusting the shocks i am running a gtu rearend
#2
registered user
iTrader: (1)
Join Date: Jan 2006
Location: San Diego
Posts: 2,469
Likes: 0
Received 0 Likes
on
0 Posts
The T2 rear end is a bolt in, you would need half shafts the complete 3rd member and a new drive shaft flange assuming your running some sort of custom drive shaft with an engine swap (my guess is V8). Depending on the U joint that your drive shaft uses I can tell you where to get the flange pretty cheap.
The T2 rear end is much stronger than any of the NA rear ends, the entire setup can probably be had for less than 500 dollars. I just put one in my 13bre powered gtu.
The T2 rear end is much stronger than any of the NA rear ends, the entire setup can probably be had for less than 500 dollars. I just put one in my 13bre powered gtu.
Thread
Thread Starter
Forum
Replies
Last Post
FC3S Timmy
2nd Generation Specific (1986-1992)
16
10-03-15 01:08 AM
Red-Dragon_Akuma
New Member RX-7 Technical
11
09-28-15 06:09 AM