for a race car i was thinking of a 62-1 Q-trim ball baring turbo on a racing beat BP engine with air->water intercooler. how fast would that turbo spool and what kind of numbers should this set up see? would 750BHP be asking alot?

Also dose any one have pics of the 62-1 on a second gen? I want to see how close of a fit it would be.
Its not a problem if it is but would that be all custom pluming for exhaust or is there a pre made kit some where for that turbo.
And i know this question will only lead to trouble but.... would 3mm seals be better for this set up? every thread iv seen about 2mm Vs. 3mm ends with out a good use 2mm for ______, and 3mm for _______. any info will be nice.

 

also has any one used the EFI ida TB and plenum?

 

well it is kinda a big turbo, so it wont spool up that fast but the ari to water intercooler is good. 720bhp is kinda but i would say go around to 560s. i dont know if i helped. are you drag racing?

 

I am preparing my Turbo II for the IDA EFI from efihardware.com currently I am working with a fabricator to contruct a custom plenum for it. I'll try and get some pics of the pre-lim instal with the velocity stacks on it. I have no idea how much that 62-1BB snail will run you but BB tah-bos! are $$.


Santiago

 

its about $1200 for the BB Q-trim. thats not bad if you compaire it to the $2700 in work for the engine.