RaceTech or Ultra-Shield seats in FD ?
#1
RaceTech or Ultra-Shield seats in FD ?
Anyone have experience with RaceTech or Ultra-Shield seats ?
http://www.discoveryparts.com/cgi-bi...seats_racetech
http://www.discoveryparts.com/cgi-bi...ts_ultrashield
I'm thinking if the Ultra-Shield's fit in a "spec Miata" they should fit in 3rd gen ?
:-) neil
http://www.discoveryparts.com/cgi-bi...seats_racetech
http://www.discoveryparts.com/cgi-bi...ts_ultrashield
I'm thinking if the Ultra-Shield's fit in a "spec Miata" they should fit in 3rd gen ?
:-) neil
#3
Rotary Freak
That 19.5" measurement for the squab in the diagram, would be a bit tight I'm thinking once you added side mounts. Dimension I seem to recall on the rhs at least, is in the 490mm range sill to tunnel sans carpet, etc.
Must say, seats without shoulder bolsters look truly weird, suppose if you see them often enough, they eventually grow on you.
Must say, seats without shoulder bolsters look truly weird, suppose if you see them often enough, they eventually grow on you.
#4
Senior Member
The ultra shield is setting on a display stand, not part of the seat.
They both will fit. Race tech will be more comfortable and would be the good street and race use. The Aluminum seat is good for short trips.
They both will fit. Race tech will be more comfortable and would be the good street and race use. The Aluminum seat is good for short trips.
Thread
Thread Starter
Forum
Replies
Last Post
Jeff20B
1st Generation Specific (1979-1985)
73
09-16-18 07:16 PM