Nrs Ceramic Seals_ Question
#1
Indifferent
Thread Starter
iTrader: (3)
Join Date: Mar 2001
Location: Long Island,NY
Posts: 979
Likes: 0
Received 0 Likes
on
0 Posts
Nrs Ceramic Seals_ Question
Has anyone tried the NRS Ceramic seals. If so- what did you clearance them at for an over 550 rwhp car, 3 or 3.5 thousanths?
Did you have to mill the housings to get the correct clearance??
Any other info you would like to share....like did you have any hard hot starting problems or anything else.
Thanks,
John
Please PM me if you don't want anyone your opinion kept private.
Did you have to mill the housings to get the correct clearance??
Any other info you would like to share....like did you have any hard hot starting problems or anything else.
Thanks,
John
Please PM me if you don't want anyone your opinion kept private.
#2
I'll blow it up real good
iTrader: (1)
Stock clearances.
No startup issues and the vacuum was 13 inches with a large street port after break in.
Also, there are a few very ruputable people using these seals from this board. Do search. One for example was just recently started by Crispeed where he posted preliminary reults.
PM Glassman (I think) on this forum. He is the guy from NRS that makes these.
No startup issues and the vacuum was 13 inches with a large street port after break in.
Also, there are a few very ruputable people using these seals from this board. Do search. One for example was just recently started by Crispeed where he posted preliminary reults.
PM Glassman (I think) on this forum. He is the guy from NRS that makes these.
Thread
Thread Starter
Forum
Replies
Last Post
Nosferatu
2nd Generation Specific (1986-1992)
7
09-05-15 02:13 PM