NA FC Rev limiter cut
02-03-12, 02:50 PM
#1
Senior Member
Thread Starter
Join Date: Jul 2005
Location: CA
Posts: 305
Likes: 0
Received 0 Likes
on
0 Posts
NA FC Rev limiter cut
Does anybody know/can tell me how to remove the rev limiter from a stock FC ECU without sending it out to someone to be disabled?
Thanks,
Eric
Thanks,
Eric
02-04-12, 01:51 PM
#2
Moderator
iTrader: (3)
Join Date: Mar 2001
Location: https://www2.mazda.com/en/100th/
Posts: 30,778
Received 2,563 Likes
on
1,823 Posts
sure, its pretty straight forward.
1. remove ecu from car
2. use your chip reader to get the data off of the eprom.
3. look in the code, find the rev limiter line, and change it.
4. since the chip isn't flashable, you need to burn a new one
5. install the new chip.
6. pat yourself on back.
1. remove ecu from car
2. use your chip reader to get the data off of the eprom.
3. look in the code, find the rev limiter line, and change it.
4. since the chip isn't flashable, you need to burn a new one
5. install the new chip.
6. pat yourself on back.
02-05-12, 12:01 PM
#3
Senior Member
iTrader: (1)
Join Date: May 2007
Location: Georgia
Posts: 387
Likes: 0
Received 0 Likes
on
0 Posts
or if you have a s4 car you can raise the rev limiter by swapping in a s5 trailing coil pack unit i did that on mine and it raised the revlimiter to 8200 instead of 7600
Thread
Thread Starter
Forum
Replies
Last Post
rgordon1979
3rd Generation Specific (1993-2002)
40
03-15-22 12:04 PM
SakeBomb Garage
Group Buy & Product Dev. FD RX-7
8
10-09-15 10:05 PM
Donald Hampton
2nd Generation Specific (1986-1992)
5
09-17-15 03:13 PM
