When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
I did a little bit of logging today in FC-Edit. I have an LC-2 setup on Gnd/AN8 on my Datalogit. I used the Innovate tool to configure the output voltage range on the LC-2, and used FC-Edit's Setup -> Auxiliary to configure the AN8 input. I basically used these instructions, but with a slightly smaller range to get a little better resolution: https://innovatemotorsports.com/reso...t_tutorial.pdf
Here is what I got after about 10 minutes of driving:
Note that some months ago I had the car professionally tuned, and I have since made a few changed (including smoothing out the timing and injector map) with FC Tweak.
Besides being quite rich, can these values possibly be accurate? They seems way too close to one-another...
Alright, of course the second I post this the answer became immediately obvious. The lower, 0V bound is set to A/F 9 for AN8. Clearly the LC-2 output wire is not connected or not enabled.
