Hello together,
I have the following problem!
I have a new rebuilt big streetport engine, and drive it with the base map (PFC)!
area in the lower speed running too rich and area in higher speed running too lean!
when I give gas at about 3000 revolutions, he takes the gas is not immediately!what can I do? where can I get maps? lambda values for and what should I pay up, have a full load and part load?
my mods:
-big street port
-stock twins
-stock ignition
-stock injection
-intercooler
-air intake
-downpipe
-midpipe
-catback
-bov and all other small things...

excuse my English is not so good = /

Many thanks in advance

regards

 

If I give gas the HEAT light sometimes lights up

 

You need at minimum:
(01) 1200 or 1600 secondary injectors
(02) proper PFC setup
(03) proper map
(04) tuned by an experience PFC-RX7 tuner
(05) wideband O2 sensor
(06) Datalogit
(07) laptop.

PM me your email address.