Hello guys!

I need a stock map where my engine leaving. I look into the power fc program and... understand nothing Now i need a stock map where runs with my setup. Or a very good setup where i have more power and i can drive a month or something. So i can read more about power fc and perfect tune on a dyno..I hope someone can help me with stock map or a little bit better stock map where i have a little bit fun before i can go on a dyno.

That's my setup:
Power FC Datalogit
Gt3582r
Bosch 044 fuel pump
850cc/1600cc fuel injectors
Afm Fuel Rail
Afm Fuel pressure regulator
Greddy FMIC
Greddy elbow
No emission controls
Downpipe without catalyst, straight pipe 3"

Fuel pressure press on which psi? 43psi? Or more?

Thank you guys!
I hope anyone can help me

 

No one can help me with a map? Or something?

 

stock maps are for stock cars

your engine isn't even close to stock

 

I just sent him a PM since our engines are similar.

 

He has not responded back to me?

 

I would love some help aswell as i have the same setup (850/1600 single turbo) and need something to work off.

 

I'm in the same boat. All ive found are maps for 3bar setups. I'm on a stock map

 

All you need to do is translate the 3 bar to 2 bar for the Settings 3 Map Ref table.
I had to do that when going from my stock 2 bar scale/offset to after I calibrated it for accuracy.

If you ever really paid attention to the PFC shown and logged boost values, you would see that they do not match your boost gauge. The PFC comes with inaccurate scale/offsets.
Most people are lazy and do not care. They just tune for the boost that they run even if the calculated P,N are not true for the boost.

The max boost that the stock map sensor can read is 17.56 psi but the PFC logs and shows
16.3 psi, that is 1.26 psi low.
I will admit that at lower boosts it is not so bad, at a true 10 psi, it is low by .94 psi.

 

.

 

I've done the recalc. And still the same issue ive had

 

i would help... but you're a D.T supporter.

 

Wat.

 

i have a pfc single turbo map for my borg warner s300sx series with 850 and 1600's /cc inj.

 

BW s366
synapse wastegate, spring pressure
550/1600 rx7 store fuel kit
supra fuel pump
stock ignition
Stock Map sensor

You can't upload a .Dat file on here so i converted it to .txt

You might be able to convert it back to a .dat but I am not 100% sure on that...

Do more searching on here for the 850 primary settings .