I am using a power fc... I did order it tuned for 14psi... but i doubt it was tuned at all...cuz i checked some parameters but they were the same as a friend of mine who bought it untuned... So i basically have an out of the box Power fc... I have the following mods


Apex-i Power Intake
Apex-i N1 Exhuast
Apex-i Gt Spec Radiator
Apex-i Power fc with commander
knightsports Downpipe
Greddy SMIC
Ported motor
Greddy Profec-e01

Attached is a map i think is close to my mods... Should i try it out??

Please advise...

 

the map i want to try it is given in the power fc maps and instruction forums... By its the map by Spyfish

 

Some feedback please!!!!!... Is spyfish's map appropriate for my mods???

 

put it this way, dont have the same porting, dont have same fuel (octane) i would say never use other peoples maps for permanent use. Use them as a starting point were you can match your mods and the mods on the maps(forum). then tune it by useing a wideband lambda and moniter to check your A/R or if you have a experienced tuner near by pop in and let hime tune it.

good luck