On the power fc, if you are in, say, monitering mode of the engine temp, and something else goes wrong with lets say the knock levels or something, will it switch screens and give you a heads up warning? It's already installed and dialed in, but I just am not sure about this and need to find the link on here with the instructions as I have none.

 

NO, the instructions do not say that!

There are 4 monitor screens which show either; 1, 2, 4, or 8 data elements.
On each of these 4 screens, you choose which of the data elements you want to monitor. You can also set them to keep track of the highest values that was shown.

 

Yeah, I figured that out later tonight after I actually read those instructions and looked at the display options a little bit.

Thanks though!