Power FC problem with PFC and secondary operation
#1
Senior Member
Thread Starter
problem with PFC and secondary operation
OK so the story goes, when the car see's any boost, ANY boost, the car stumbles. It was determined that the secondaries are not working at all. I checked every possible thing and they are fine, the wiring is fine, resistors are fine, ect.
Now I have to verify this tomorrow with another test drive, but it appears that with the car cold, the secondaries operate, when the car warms up they don't??
ANYONE HAVE A CLUE?????
Now I have to verify this tomorrow with another test drive, but it appears that with the car cold, the secondaries operate, when the car warms up they don't??
ANYONE HAVE A CLUE?????
Last edited by turbovr6; 05-15-03 at 06:48 PM.
#2
Eye In The Sky
iTrader: (2)
Join Date: Feb 2001
Location: In A Disfunctional World
Posts: 7,895
Likes: 0
Received 114 Likes
on
66 Posts
The only way to verify that is to measure the voltage across the secondaries. Any boost; I do not think the secondaries come on at very low boost. If you engine stumbles even as vacuum goes to .5PSI boost, then it is not the injectors.
What engine work if any was been done between a good running engine and now?
What engine work if any was been done between a good running engine and now?
Thread
Thread Starter
Forum
Replies
Last Post
Jeff20B
1st Generation Specific (1979-1985)
73
09-16-18 07:16 PM