I am checking the innovative form as well but thought I would check here also. Everything was working together fine before but I thought my unit had issues and remover it to send back only to find out it was a bad sensor. Now my A/f gauge reads fine but when I try and log a run it is reading wrong. Instead of idle at 10's to 11's (as gauge shows) its logging 15.4 area. LC-1 is set on (gas) and settings are correct on there as well as FC edit aux. set up. Everything is the same as before! Just logging gives wrong info? This sucks as everything is set for the dyno, I just need to be able to log and do some high boost pulls and adjust A/R's now.....

 

The DL AUX inputs have to be setup correctly for the WB.
The Innovative site does have info about doing this to a DL.
Have you looked there?

 

Could you have reversed the wires going to the datalolit? Yellow/brown to AN1 and green/ground to the datalogit COM. AFR corrections 10.2 and 20.2 for 0 and 5 volts.
Barry