just wondering if you guys can help me with my injector map. i have stock primaries 550's and 1200 secondaries just wonderin if anyone has any advice of how to make it run smoother at the higher rpms. right now when i get up about 3600rpm it doesnt boost past .25 bars and im thinking its too rich any advice is appreciated

thanks adam

 

Have the settings been changed in the PFC for the larger secondaries? Did the car boost fine before the installation of the secondaries?

 

well the car was down for 10 months while i was getting a new engine. i decided to upgrade everything on it and i dont think they have been modified to fit the secondaries because when i boost it it feels like it breaks up after 4500rpm and stutters then when i get off the temperature rises a good 3 celsius so i just want it to be fine in boost wise that way i dont overheat the car and cause any serious damage for now until i can get it dyno tuned with a new ignition

 

Well get in there and tune those lil nasty settings! If you got 1200s and the setting say 850s, no wonder it's flooding like the Mississippi river after a heavy spring thaw!

Just follow the instructions in the manual.

And then thar is that tricky lil devil called a SEARCH FUNCTION.

 

hahah yea ive tried should i just reset it to stock settings because i actually sent it to the rx7store to have them give me a base map first but they accidentally screwed up all the settings and put my primaries as 1000cc and secondaries as 1680cc and how do i go about figuring out what to change it to?

 

The instructions that came with it, or that are available on the net tell you what to do. It is basic learning.

 

ok thanks for the help do you mind if i post what i have done after im done making a map and everything for it. i am going to go back to factory defaults and to start over and also am trying to get someone to lend me there datalogit and maybe wideband