Power FC PFC Map question
11-06-03, 01:35 AM
#1
Banned. I got OWNED!!!
Thread Starter
Join Date: Jun 2003
Location: Central Florida
Posts: 1,619
Likes: 0
Received 0 Likes
on
0 Posts
PFC Map question
Ok I have a map that I got a while ago off the boards that was for a intake, downpipe, midpipe, catback and ported motor. I was curious will this map work fine on a car with a intake, downpipe, catback, pulleys, efni y pipe? If so, how do I load this up to the pfc?
11-06-03, 06:02 AM
#2
If you want assurances about a map you really need to know what it was setup for regarding fuel type, boost, fuel system, AFR, etc. I would only run someone else's map if I knew their setup exactly and what it was tuned for (conservative, afr, etc) and and and.
To program your ecu you simply input their map data using a commander or datalogit ... if the map is off a datalogit you better use a datalogit to reprogram your ecu as the base fuel maps may have been changed. Just don't make a mistake and be sure to fix any negative split.
To program your ecu you simply input their map data using a commander or datalogit ... if the map is off a datalogit you better use a datalogit to reprogram your ecu as the base fuel maps may have been changed. Just don't make a mistake and be sure to fix any negative split.
Thread
Thread Starter
Forum
Replies
Last Post
rx8volks
Canadian Forum
0
09-01-15 11:02 PM
