Power FC Peak Hold
#1
Senior Member
Thread Starter
Peak Hold
Normally, I have my Commander in a 4-channel mode displaying water and air temps, boost, and injector duty along with its peak readings. Is the commander capable of 'real time' and peak readings in 8-channel mode? I can only set it to display one or the other, but not both simultaneously. I didn't find it mentioned in the instructions, and there doesn't appear to be enough room on the screen anyway.
Also, has this ever happened to anyone? My air temp peak hold was reading '----', but was still giving a correct 'real time' reading. I did the ol' key off-key on, and the Commander reset itself. This has only happened once, and has been ok since.
Thanks for your help.
Also, has this ever happened to anyone? My air temp peak hold was reading '----', but was still giving a correct 'real time' reading. I did the ol' key off-key on, and the Commander reset itself. This has only happened once, and has been ok since.
Thanks for your help.
#3
Senior Member
Thread Starter
Thanks for the response, skotx. I didn't think I was missing anything concerning the 8-channel display. As for the air temp reading, I'll look into it if it ever happens again. Thanks.
Thread
Thread Starter
Forum
Replies
Last Post
Turblown
Vendor Classifieds
12
10-17-20 03:25 PM
joel(PA)
Group Buy & Product Dev. FD RX-7
8
10-04-15 06:07 PM
FC3S Timmy
2nd Generation Specific (1986-1992)
8
10-02-15 08:08 AM