Power FC noob Q about PFC
#1
Full Member
Thread Starter
Join Date: Jan 2004
Location: OHIO
Posts: 113
Likes: 0
Received 0 Likes
on
0 Posts
noob Q about PFC
I just bought a PFC my mods are a cb, profec b, boost guage, A/F guage, and water temp guage. so my car is pretty muck stock. I was wondering if i installed the PFC with only these mods if will hurt my engine, and if i do install it should i keep the boost at 10lb or will it be ok to turn it up. And by the way I do plan on moding the car more i just wanted to get the PFC out of the way.
#2
Lives on the Forum
Join Date: Dec 2001
Location: San Lorenzo, California
Posts: 14,716
Likes: 0
Received 8 Likes
on
8 Posts
You will be perfectly fine on the base maps with only a cat-back. Keep the boost at 10 psi if for no other reason than trying to run higher than 10 psi with a stock (near) car is really hard on the turbos.
The default setting is about 11.x psi on the PFC so you shouldn't have to adjust anything. Since you have a Profec, you just want to make sure that the target boost setting on the PFC is always higher than the boost level you are setting with the Profec.
The default setting is about 11.x psi on the PFC so you shouldn't have to adjust anything. Since you have a Profec, you just want to make sure that the target boost setting on the PFC is always higher than the boost level you are setting with the Profec.
#3
Full Member
Thread Starter
Join Date: Jan 2004
Location: OHIO
Posts: 113
Likes: 0
Received 0 Likes
on
0 Posts
dude you are pimp you are always coming to the rescue.
if you dont remember you gave me a write up on how to tune the profec thanks a bunch you are the ****.
if you dont remember you gave me a write up on how to tune the profec thanks a bunch you are the ****.
Thread
Thread Starter
Forum
Replies
Last Post