Power FC No change while using PFC commander
#1
- Make Haste -
Thread Starter
Join Date: Apr 2005
Location: Calgary, Alberta
Posts: 1,648
Likes: 0
Received 0 Likes
on
0 Posts
No change while using PFC commander
when i use my commander to make a few little changes on the fly the values change but on my wideband however, they do not....
i'm trying to clean up what i feel may be a slight lean spot on my map and before i get flammed, yes, the datalogit is ordered and on it's way....
right when it gets on boost (1-2psi) it's running high 13's for AFR, however anything above that it drops to ~11:1 AFR, i have richened the area up quite a bit yet no change is noticed, why is this?...
also, is 13.9:1 AFR at 1-2psi of boost something to worry about?, what about mid 14's while cruising in vac. on the highway?...
thanks again....
i'm trying to clean up what i feel may be a slight lean spot on my map and before i get flammed, yes, the datalogit is ordered and on it's way....
right when it gets on boost (1-2psi) it's running high 13's for AFR, however anything above that it drops to ~11:1 AFR, i have richened the area up quite a bit yet no change is noticed, why is this?...
also, is 13.9:1 AFR at 1-2psi of boost something to worry about?, what about mid 14's while cruising in vac. on the highway?...
thanks again....
Thread
Thread Starter
Forum
Replies
Last Post