The idle doesn't bounce, but my stalling problem wasn't totally fixed by adjusting the air bleed screw. I also tried to disable the O2 sensor setting in the PFC with no help.

The car only stalls after warm up. My thought is that the car isn't getting enough gas, is this logical? Can I just increase the amount of gas in this area of the map???

Or is there something else I am missing

 

Read page 30 of the manual. If you can get the engine to idle by adjusting fuel here, then you will be able to do the same with the fuel cells associated with idling.

Idling cells are usually rows P3 - P4 and columns
N2 to N3. This can be verified with the map trace function.

 

Yup, I was there Thanks alot! I brought my computer with the excel spreadsheet basemap as I was comparing the info...

Well, what acutally fixed it was the stupid idle adjustment screw!!!!! FUDGED!

I know alot of people have problems with the idle and PFC....and I have dont a search...

but those referencing this thread...

1) if your idle is bouncing try to adjust the air bleed screw first (close position)

2) if your idle is fine but stalls then change the idle adjustment....

I hope this lasts....
if this fails then I will be looking at the maps again