Power FC In need of a MAP...please help
07-01-03, 12:53 PM
#1
In need of a MAP...please help
If anyone can help me, that would be great. I need a base map for my car in order for it to start and run ok so that I can go get it tuned.
Here are my mods:
BNR Race Ported Motor (large street port)
GT35/40
Blitz FMIC
756/1680 injectors
A1000 FP
HKS twin power
Full Exhaust
3 Bar Map sensor
I think that is all that matters as far as a base map is concerned.
I know for the 3Bar MAP sensor to go to Option 2 and set the scale to 41,800 and the offset to 0. But I need some sort of rich map with safe timing, so that I can drive my car for the break in period and get it set up for a dyno tuning in a few weeks.
If anyone has mods similar to these, I am willing to pay for a map.
Thanks,
Scott
Here are my mods:
BNR Race Ported Motor (large street port)
GT35/40
Blitz FMIC
756/1680 injectors
A1000 FP
HKS twin power
Full Exhaust
3 Bar Map sensor
I think that is all that matters as far as a base map is concerned.
I know for the 3Bar MAP sensor to go to Option 2 and set the scale to 41,800 and the offset to 0. But I need some sort of rich map with safe timing, so that I can drive my car for the break in period and get it set up for a dyno tuning in a few weeks.
If anyone has mods similar to these, I am willing to pay for a map.
Thanks,
Scott
07-01-03, 12:58 PM
#2
Eye In The Sky
iTrader: (2)
Join Date: Feb 2001
Location: In A Disfunctional World
Posts: 7,895
Likes: 0
Received 114 Likes
on
66 Posts
Do you have a DATALOGIT, that is what it will take for some of the changes to be done properly. Plus their Yahoo Group does have xx.dat files posted for downloading.
07-01-03, 10:31 PM
#6
Where is my FPR? In my engine bay...
I have an SX FPR, -10 Feed into a distribution Block with -8 lines feeding both rails in parallel and a -8 return to the tank.
Why is it a silly pump? I know tons of people who have had awesome luck with the A1000....I did not want to push a puny pump too hard, nor did I want to **** around with dual baby pumps so I got an A1000. It should be enough for anything I ever may decide to do. I had my A1000 mounted in tank as well to quiet down the noise and keep it running cooler.
I am not running any water injection yet, I am thinking about it though. I just need a map to get my car running safe enough to break it in.
I have an SX FPR, -10 Feed into a distribution Block with -8 lines feeding both rails in parallel and a -8 return to the tank.Why is it a silly pump? I know tons of people who have had awesome luck with the A1000....I did not want to push a puny pump too hard, nor did I want to **** around with dual baby pumps so I got an A1000. It should be enough for anything I ever may decide to do. I had my A1000 mounted in tank as well to quiet down the noise and keep it running cooler.
I am not running any water injection yet, I am thinking about it though. I just need a map to get my car running safe enough to break it in.