Hi all,

hopefully someone could help me out or tell me how you all have done this. The problem that I have is that i have now taken away the stock ecu and was about to put all the harness back on to the pcf when I discovered that the stock ecus holding brace didn't fit to the pcf. How have you installed it? Is there any good way of putting it back to the original place or is the only possibility to use duck tape..
Thank you in advance for all your help.

 

you're pretty much on your own. zipties, velcro, custom bracket, whatever.

 

damn.. so there's no standard that you all would have gone with..
well i'll then just have to find some way of putting it there.

 

Time for you to start thinking like a real mechanic!

 

yep.. have started to plan a bracket that will fit the original place.. so it's under the way..

 

i use 3M rubber double-sided tape. helps cushion the ecu from vibration as well.. =P

i've seen some ppl just leave the PFC on the floor...

 

There are many roads to take but not all end up in the same place with the same experience.

Simplicity is better.