Power FC Map points
Thread Starter
Joined: Oct 2001
Posts: 456
Likes: 0
From: Orange County, CA
sorry....utec offers 36 RPM sites from 250 RPM to 9000 RPM and 10 load sites, the UTEC gives you 360 possible map points for fuel, ignition timing, and boost.
Can the power fc match utec or more?
Thanks
Can the power fc match utec or more?
Thanks
Lives on the Forum
Joined: Dec 2001
Posts: 14,716
Likes: 10
From: San Lorenzo, California
The PFC has a 20x20 matrix for rpm vs load (400 cells).
The default range is from 400-8000 rpm (every 400 rpm) and from about -27 inches to 19 psi. The load range can be changed with the Commander. I'm not sure if you can change the rpm or not with the datalogit (for those running a bridgeport....
The default range is from 400-8000 rpm (every 400 rpm) and from about -27 inches to 19 psi. The load range can be changed with the Commander. I'm not sure if you can change the rpm or not with the datalogit (for those running a bridgeport....
Lives on the Forum
Joined: Dec 2001
Posts: 14,716
Likes: 10
From: San Lorenzo, California
Me neither. The only negatives I have read about or discovered personally are the spotty A/C and the need to buy the data-logit for full control.
Considering the fact that the Haltech and TEC III systems can't even run the oil metering pump and require a complete re-wiring of all the engine sensors.....
Considering the fact that the Haltech and TEC III systems can't even run the oil metering pump and require a complete re-wiring of all the engine sensors.....
Thread
Thread Starter
Forum
Replies
Last Post
toplessFC3Sman
2nd Generation Specific (1986-1992)
6
Mar 20, 2018 01:54 PM
eddierotary
Engine Management Forum
16
Oct 4, 2016 08:22 PM
23Racer
Race Car Tech
1
Sep 21, 2015 10:48 AM
The1Sun
1st Generation Specific (1979-1985)
7
Sep 18, 2015 07:13 PM