If any of you guru's have any input, it would be much appreciated. Any ideas why, for some reason, the PowerFC would show 0 as my speed? It has no other problems showing RPM or any other data.

My speedometer does work as well as my tach and all other gauges.

Thanks,

Ian

 

About the speed problem, never heard of it, but I know of one case where one owner's PFC displayed battery voltage as if it was divided by 10.

I would suggest that you look up which harness pin is for speed, and insure that that pin has not backed out of it connector.

If that is not the problem, you could try :
1) write down all the data in all the tables visable with the commander
2) re-initialize the PFC
3) re-enter any data that changed
Access to a DL would make this very easy.