Power FC Installed power FC on my FD with new ENG.
Thread Starter
Man Whore
Joined: Feb 2001
Posts: 329
Likes: 0
From: Gainesville
Installed power FC on my FD with new ENG.
ok... since my engine now has like 0 boost for a few hundred miles...
Will I need new maps for it when it's done breaking in and boosting 12psi and where can I git them if I do?
3mm
Ported
8.5# flywheel
6 puck clutch w/springs
Fluydine rad.
Stock IC
Stock Turbos
power pulley
Intake
Down Pipe
Mid Pipe
Cat back
Will I need new maps for it when it's done breaking in and boosting 12psi and where can I git them if I do?
3mm
Ported
8.5# flywheel
6 puck clutch w/springs
Fluydine rad.
Stock IC
Stock Turbos
power pulley
Intake
Down Pipe
Mid Pipe
Cat back
uid 0
Joined: Mar 2001
Posts: 858
Likes: 1
From: San Francisco, CA
There are maps available here on the forum. I'm new to the whole PFC thing myself, but I think you just need to install the maps for a car that has the same or similar mods and you'll be good.
Here's a link to the maps section here on the PFC forum...
https://www.rx7club.com/vforums/show...threadid=10509
Here's a link to the maps section here on the PFC forum...
https://www.rx7club.com/vforums/show...threadid=10509
Thread
Thread Starter
Forum
Replies
Last Post