Power FC Injector Map Value Won't Allow > 1.5??
#1
Ferrari Red Hotness
Thread Starter
Join Date: Nov 2005
Location: Las Vegas
Posts: 964
Likes: 0
Received 0 Likes
on
0 Posts
Injector Map Value Won't Allow > 1.5??
Last night when tuning my car on the dyno, I noticed that using the DATALOGIT, the highest number we could set an injector map cell to was 1.5, which would then be rounded to 1.496
Is there a reason for this? I've seen plenty of maps with values set higher than this, so I was a bit confused. Thanks
Is there a reason for this? I've seen plenty of maps with values set higher than this, so I was a bit confused. Thanks
#2
Eye In The Sky
iTrader: (2)
Join Date: Feb 2001
Location: In A Disfunctional World
Posts: 7,895
Likes: 0
Received 114 Likes
on
66 Posts
That 1.49 or 149% max value limitation only applies to the COMMANDER.
With the DATALOGIT, you can use the RECALC function to take the fuel correction values and apply them to the base fuel map. This resets the correction map back to all 1s which is 100%. And it also ***** up the O2 feedback for idle and cruise; there is a way around this, it has been posted here or buy my tuning notes which tell this and more.
With the DATALOGIT, you can use the RECALC function to take the fuel correction values and apply them to the base fuel map. This resets the correction map back to all 1s which is 100%. And it also ***** up the O2 feedback for idle and cruise; there is a way around this, it has been posted here or buy my tuning notes which tell this and more.
#3
Ferrari Red Hotness
Thread Starter
Join Date: Nov 2005
Location: Las Vegas
Posts: 964
Likes: 0
Received 0 Likes
on
0 Posts
Gotcha, just wanted to check because I was using a datalogit to change the values, but it would automatically reset them to 1.496 as soon as I entered a higher number. I'll search for your re-calc section in the tuning notes. THanks
Thread
Thread Starter
Forum
Replies
Last Post
trickster
2nd Generation Specific (1986-1992)
25
07-01-23 04:40 PM
Skeese
Adaptronic Engine Mgmt - AUS
65
03-28-17 03:30 PM