guys,

i've searched it all on the web but doesn't seem to find an answer for this question of mine. this is what i observed.

i set the IGL-IGT Split settings at 12 for P15 to P20 and N12 to N20.

after awhile like say a few days.... the number starts to jump around... supposed that whole area should look like all 12... but some of the numbers inside changed to 10, some to 9, some to 8....

why PFC changes this themselves ? do we have an explanation over here for this ?

 

Is it just say at the edge of the rows like P15, if so it could be where it interpolates between P15 and P14.

 

If your actual maps are changing, then replace the PFC.

 

Or try re-initializing the PFC and then reload your map.
If it still is unstable then do as rynberg says!

 

replace the PFC is pain in the ***.... it's not cheap.. anyway, let me try to reinitialize. and see how it goes.. hopefully it's not the electrical issue.

 

it looks like the PFC retards the number. the amount they retard is exactly like the amount of retard the settings 4 pre-set. but in a certain line only.

i'll double check all electrical stuffs first.. then re-initialize... and try again.

 

okay i found hte problem..
i accidently retarded the IGL... and the IGT split will change itself as well

my bad :P