Power FC "global" injection trim on PFC ?
04-10-06, 02:08 PM
#1
Infamous...Butcher...
Thread Starter
Join Date: Feb 2002
Location: WA
Posts: 510
Likes: 0
Received 0 Likes
on
0 Posts
"global" injection trim on PFC ?
Is there any way to bump the entire map up a little for fuel everywhere? I don't want to mess with the individual points, or the curve.. just simply put a slight gain on the injection to richen it up everywhere. IF I had an adjustable regulator I'd just bump it up a poundor so... any tips?
04-10-06, 02:12 PM
#2
Senior Member
Join Date: Feb 2005
Location: Germany
Posts: 427
Likes: 0
Received 0 Likes
on
0 Posts
You can either adjust the "Injection vs. RPM" settings or the injector settings.
You can change both settings with the Commander, "PIM Volt" > Next > "Engine RPM Specific Correction" or "Injector" and then change the Injector Pulse Correction.
You can change both settings with the Commander, "PIM Volt" > Next > "Engine RPM Specific Correction" or "Injector" and then change the Injector Pulse Correction.
Last edited by FastHatch; 04-10-06 at 02:16 PM.
Thread
Thread Starter
Forum
Replies
Last Post