Power FC FC Commander Pro Software
Thread Starter
aaron o
Joined: Feb 2007
Posts: 13
Likes: 0
From: Greenville, OH
FC Commander Pro Software
Good afternoon,
I have:
-86 GXL NA
-PFC with Banzai adapter
-3 bar map sensor from Banzai
-Fc Commander Pro software
I know data log it and the FC edit software is a lot more popular. But I purchased the commander pro software thinking it would do everything I would want to do, maybe that was a mistake.
I believe the Commander Pro software will work for me except that I can’t “calibrate” the PIM/Volt settings. It is my understanding that the FC-Edit software allows the user to adjust the “offset” for each PIM selection to make it as close to 0 as possible with the engine off. My Map sensor reads -450 mmhg through -230 mmhg depending on which PIM option is selected.
Does anyone know if this is possible or if there is a way to make it work using just the Commander Pro software?
I have:
-86 GXL NA
-PFC with Banzai adapter
-3 bar map sensor from Banzai
-Fc Commander Pro software
I know data log it and the FC edit software is a lot more popular. But I purchased the commander pro software thinking it would do everything I would want to do, maybe that was a mistake.
I believe the Commander Pro software will work for me except that I can’t “calibrate” the PIM/Volt settings. It is my understanding that the FC-Edit software allows the user to adjust the “offset” for each PIM selection to make it as close to 0 as possible with the engine off. My Map sensor reads -450 mmhg through -230 mmhg depending on which PIM option is selected.
Does anyone know if this is possible or if there is a way to make it work using just the Commander Pro software?
Thread
Thread Starter
Forum
Replies
Last Post
13bmaniac
Power FC Forum
6
Nov 5, 2007 05:32 PM