Power FC Datalogit settings for TE 2B0 reference ground (searched)
Thread Starter
Rebreaking things
Joined: Jun 2001
Posts: 2,586
Likes: 0
From: 1 foot in Boston 1 in NJ
Datalogit settings for TE 2B0 reference ground (searched)
I have the 0-5v output hooked up to AN1 the reference ground connected to AN2. I clicked the AN1-AN2 delta box.
For AN1:
0v=9afr
5v=19afr
I left the polynomial section alone. Based on what I have read I believe it defaults to a linear line.
For AN2:
0v =0v
5v =5v
Is that corect, or should I use the same settings as in AN1?
For AN1:
0v=9afr
5v=19afr
I left the polynomial section alone. Based on what I have read I believe it defaults to a linear line.
For AN2:
0v =0v
5v =5v
Is that corect, or should I use the same settings as in AN1?
Thread
Thread Starter
Forum
Replies
Last Post
streetlegal?
New Member RX-7 Technical
13
Mar 17, 2022 02:46 PM
