I installed my PLX wideband today. I have the dashpod showing values (I hope correctly), but I'm not getting anything from my datalogit.

I connect AN1 to +5v and AN2 to ground.

Here's my setup:



Did I miss somehting?

 

The wiring sounds right but if you are using a diffrential input (using a1 nd a2) you should check the Delta AN1 - AN2 box, this will account for float ground differentials between the wideband and the datalogit... I had to use AN3 and 4 on mine since a terminal was broken from the board from being torqued too tight (by me oops) I don't know about your wideband, do you have to enable the analog output maybe?

 

Did you use the filtering capactors in your setup?

 

I just hooked the analog out from the wideband controller right up to the analog in no caps... There may be some internal filtering on my wideband? Signal is pretty clean I am using the innovative lm2 I think that is the model number? ...

 

I'll try again tomorrow with that box checked. Tonight I have class so no time for toys.