Power FC Commander going blank after inital start up screen.
#1
Full Member
Thread Starter
Join Date: Feb 2001
Location: Bay Area
Posts: 59
Likes: 0
Received 0 Likes
on
0 Posts
Commander going blank after inital start up screen.
anyone have problems with their commander going blank after inital display of the Apex start up screen... sometimes I am able to display data but soetimes it just goes blank...
grr I am about to check the wiring, but have to wait till the end of this work day.
-M
grr I am about to check the wiring, but have to wait till the end of this work day.
-M
Thread
Thread Starter
Forum
Replies
Last Post
ray green
1st Gen General Discussion
2
09-02-15 06:35 AM
rx8volks
Canadian Forum
0
09-01-15 11:02 PM