Power FC Can the PFC control additional injectors?
Can the PFC control additional injectors?
06-19-06, 11:35 AM
#2
Cant be bothered anymore
Join Date: Aug 2004
Location: Norwich UK
Posts: 465
Likes: 0
Received 0 Likes
on
0 Posts
Yeah it can be used to fire 6 injectors. I think you have to piggy back a set and alter the settings for those injectors. ie 2 sets of 850cc secondaries or 2 sets of 550cc primaries
Scott
Scott
06-19-06, 06:02 PM
#3
Full Member
Join Date: May 2006
Location: Albuquerque, NM
Posts: 55
Likes: 0
Received 0 Likes
on
0 Posts
I was reading somewhere in the manual about using 4 injectors for the secondaries. You goota becarefull with what injectors you use because the PFC uses FET's to control the voltage to the injectors and if you pull to many watts 3Watts max you'll blow the FET's.
Last edited by RSXJOSH; 06-19-06 at 06:09 PM.
06-21-06, 09:19 AM
#4
RX-7 Bad Ass
iTrader: (55)
It would take a little bit of electronics thinkin' to do the job. Probably better to run 2 low impedance injectors with a resistor off one driver than 2 high impedance injectors.
Dale
Dale
Thread
Thread Starter
Forum
Replies
Last Post
imitek
3rd Generation Specific (1993-2002)
9
08-28-15 05:28 PM