Power FC AP Engineering S5 PowerFC.....no knock sensor?
#1
AP Engineering S5 PowerFC.....no knock sensor?
My car is freshly built and soon to be dynoed. I'm running an AP Engineering PowerFC specifically made for S5 FC's. The PDF instructions say "Non-Functioning items - sequential turbo system, e-fan, fuel temp, knock"
I understand this is because the PFC is originally an FD unit converted to FC.
BUT....s5 FC's do have knock sensors. Should I figure out a way to wire up the knock sensor? Or should I dyno it without one.
p.s. car runs fine btw i've put about 100 miles on the basemap and i've stayed out of boost.
THANKS!
Apexi link below:
http://www.apexi-usa.com/manuals/ele...stallation.pdf
I understand this is because the PFC is originally an FD unit converted to FC.
BUT....s5 FC's do have knock sensors. Should I figure out a way to wire up the knock sensor? Or should I dyno it without one.
p.s. car runs fine btw i've put about 100 miles on the basemap and i've stayed out of boost.
THANKS!
Apexi link below:
http://www.apexi-usa.com/manuals/ele...stallation.pdf
Last edited by Sash91; 02-27-18 at 12:23 PM.
Thread
Thread Starter
Forum
Replies
Last Post
Slash200
3rd Generation Specific (1993-2002)
1
07-25-15 11:31 PM
)EIB(
Power FC Forum
0
01-01-08 03:14 PM
HIMNI Racing
Microtech
4
06-02-03 08:01 AM