Power FC Anyone using a MSD 3 bar MAP w/PFC?
Thread Starter
Joined: May 2001
Posts: 5,030
Likes: 4
From: Parlor City, NY
Anyone using a MSD 3 bar MAP w/PFC?
Has anyone had any luck using the MSD 3 bar map sensor with the PFC?
I would assume the settings would be like the GM sensor, except this one can be purchased for cheaper.
http://store.summitracing.com/defaul...?part=MSD-2313
I would assume the settings would be like the GM sensor, except this one can be purchased for cheaper.
http://store.summitracing.com/defaul...?part=MSD-2313
Should work fine if it uses 14V for power. Just run some tests with a pressuized air source to find out.
That's a good price and probably worth the testing, they should allow you to return it after testing if you never install it.
That's a good price and probably worth the testing, they should allow you to return it after testing if you never install it.
Thread
Thread Starter
Forum
Replies
Last Post
eddierotary
Engine Management Forum
16
Oct 4, 2016 08:22 PM
