Power FC 8 Channel Display Setup?
#1
8 Channel Display Setup?
How can you change what displays on the 8 Channel display? Before my Commander would display battery voltage, air temp, water temp, injector duty, IGN Timing, Knock, Boost, Rev.
Just like how this guy has his setup
I reset the PFC when getting the car running for the first time, and now it only displays Battery Voltage, Water temp, Injector duty, IGNT Timing, INGL Timing, Boost, Knock, and Rev.
Is Datalogit needed to change what displays?
Any help would be greatly appreciated.
Just like how this guy has his setup
I reset the PFC when getting the car running for the first time, and now it only displays Battery Voltage, Water temp, Injector duty, IGNT Timing, INGL Timing, Boost, Knock, and Rev.
Is Datalogit needed to change what displays?
Any help would be greatly appreciated.
#4
rotorhead
iTrader: (3)
I just looked at their website and it seems that whoever redid it recently messed a lot of the PFC stuff up. The instructions aren't on there anymore, and they are listing a bunch of Power FC's that have been long since discontinued. PM me and I can email you the instructions if you want them.
Thread
Thread Starter
Forum
Replies
Last Post
Wicked93gs
2nd Generation Specific (1986-1992)
42
10-07-15 11:58 PM
killerrx710
Adaptronic Engine Mgmt - AUS
5
09-28-15 09:13 AM
killerrx710
2nd Generation Specific (1986-1992)
1
09-24-15 10:57 PM