sen2two

iTrader: (10)

I have been emailing, calling, and looking everywhere all over the country for someone willing to cut up there junk Rx2 to get some metal to fix my 72 coupe. I have found a few people who say they will, and then never come through.

So I'm asking now. This is what I need. Pics and descriptions below...

So if you know someone or somewhere I can get this from, PM me asap or send them a link to this thread. This would be greatly appreciated. And would bring another Rx2 back to life!!!


This is needed so i can weld in my new frame rails. I do not believe the metal there is strong enough for me to weld in good clean new metal. So i would like to replace it with un-rusted metal. What I need is inside the red lines below. I do not need it to be in one piece. What I mainly need is there area half way up the fire wall down to the seat bracket area. I need each side. I really don't need the trans tunnel. There must be ZERO rust on the metal. I'm located in Kissimee, Florida.











I will also need both rear quarter panels and the lower rocker from front to rear on the passenger side. A clean set of front fenders would be nice also. Put the word out!!!

WAS:12A

iTrader: (4)

https://www.rx7club.com/old-school-other-rotary-63/who-needs-rx-2-a-940816/

sen2two

iTrader: (10)

Contacted him already. Shipping alone for the entire car would be about $1300 alone... Hopefully I will be able to get him to cut some metal for me if no one buys it.