hi how can i fit rx7 front struts with hubs and disk brakes into my rx3?



is there a post with step by step or some pics at least?

thanks
tyler

 

It is not a bolt on swap. You will have too much positive camber. At a minimum you will have to run caster/camber plates.

 

At this time I'm in the finel steps of swapping in a 1st gen in to a 75 RX4, and evey thing is fitting just fine. If you go to the NW section you will finde what I have been doing or I can send you CD full of pic on swapping in a 2nd gen front and rear complet on a 76 RX4

 

the front strut is a bolt on, but you'll need a camber plates to bring the camber back in. get in touch with billy he's got a group buy on the camber plates.
https://www.rx7club.com/group-buy-center-69/respeed-rx3-sa-fb-camber-plate-kit-gb-476799/

 

ya if you could send me pics that would be awsome

 

sorry above post is me i didnt realize i was logged in as my brother.


thanks for the reply

also i went through some of your old posts gambone and i didnt see the thred with the pics.

link me?