guys happy new years to everyone!!!!!!!!!!
I got a question would the whole drive train from a first gen fit on a 73 rx3 wagon..and without doing too much modificatons........just wonder if any one had gone thru this before.........thanks any info would be appreciated.......

 

Easily done with only minor modifications. Engine and gearbox that is.

 

For the header, depending on your motor, use the single outlet to clear the idler arm. 79-82 short radiator and oil cooler

 

would the the complete rear axle fit,,because if im not mistaken i once measure the length of the axle and it seem longer than the original axle from the wagon............thanks for the replies......

 

There was a bit of discussion on a similiar subject concerning a gsl-se drivetrain on rx3club. If you want to check it out Click Here