RX-3SP :puttin' n' work
#1
Rotary Enthusiast
Thread Starter
RX-3SP :puttin' n' work
Like I said in the other post I just got a new (cheap) digi. camera. And now have begun working on the body work of the car. Its going to be a while but I got a lot of inspiration from the forum to stop f..ing with my T2 and pay some attention to the "grandfather". I'ma try and work a little at a time every day after work and on weekends into the night til i get the ody work finished and pull the motor to paint. Well here's the first day guys.( working through and after WILMA)The pieces Im using to make the patches are off the scrap quarter panels and door skins we throw away at my job, so I just bring them home to recycle the whole car is in need of mudwork but the lower quarter panel that you see I cut out is the worst of it thats why I started there. Im still in need of the SP decal kit as well as a rear bumper w/ brackets. So if you guys run acrooss one hook a brother up
#2
Rotary Enthusiast
Thread Starter
some more pix'
As far as body work is concerned I have no questions but when it comes time to pull the motor and tranny you guys will definately be hearing from me!! also the whole drivetrain will be out to sandblaswt and re undercoat the whole undercarriage
#3
Rotary Enthusiast
Thread Starter
still cutting hammer and dolly work is needed before I can tack weld the patch into place also I have to clean up the inner quarter as it has started to take a **** on me too. but tomoorow I will bring hammer and dolly. Today I was working like fred flinstone(w/ whatever I could find)-Erik
Thread
Thread Starter
Forum
Replies
Last Post
maikelc
3rd Generation Specific (1993-2002)
8
08-24-15 11:04 AM