My 73 rx3 work in progress
#376
I actually own Rotaries
Thread Starter
iTrader: (40)
Thank You Daimhin for posting the video!!! I am not a great camera man!!
#378
I actually own Rotaries
Thread Starter
iTrader: (40)
Thanks Manny... I will be doing that soon too!!! Thats one of the main reasons i am truing to get this car finished
#381
The General RE
#385
I actually own Rotaries
Thread Starter
iTrader: (40)
#388
I actually own Rotaries
Thread Starter
iTrader: (40)
Thanks guys!!!!
#391
I actually own Rotaries
Thread Starter
iTrader: (40)
#394
I actually own Rotaries
Thread Starter
iTrader: (40)
#395
I actually own Rotaries
Thread Starter
iTrader: (40)
Quick update...
I completed the disc brake conversion using the older model brackets from REspeed..
I have all the thick walled piping (11 gauge) and all the mandrals to complete my exhaust. I will be going to have it all put on this Saturday!!! I still havent completely figured out exactly how the exhaust will be done but its looks like for now something very similar to RB street port long primary up and over the rear and collecting into one 3inch muffler??? kinda scared of it being too loud but Im hoping that the thick walled tubes along with the 2 RB pre silencers it will be tolerable??? any ideas are welcomed
I completed the disc brake conversion using the older model brackets from REspeed..
I have all the thick walled piping (11 gauge) and all the mandrals to complete my exhaust. I will be going to have it all put on this Saturday!!! I still havent completely figured out exactly how the exhaust will be done but its looks like for now something very similar to RB street port long primary up and over the rear and collecting into one 3inch muffler??? kinda scared of it being too loud but Im hoping that the thick walled tubes along with the 2 RB pre silencers it will be tolerable??? any ideas are welcomed
#397
I actually own Rotaries
Thread Starter
iTrader: (40)
finally out of the garage
drove it down and loaded it on thr trailor today!!! open header!!! going to get exhaust tomorrow!! here are some pics
#399
The General RE
What configuration did you settle on for your exhaust system?
Long primary, two RB presilencers and a 3" main muffler?
See if you can get the tube lengths to the presilencers to be equal. They have an anti-reversion chamber on the inlet side that becomes the exhaust tuning point.
What are you going to use for a collector?
Here's the RB specs for your reference:
Long primary, two RB presilencers and a 3" main muffler?
See if you can get the tube lengths to the presilencers to be equal. They have an anti-reversion chamber on the inlet side that becomes the exhaust tuning point.
What are you going to use for a collector?
Here's the RB specs for your reference:
#400
I actually own Rotaries
Thread Starter
iTrader: (40)
yes!! I have the RB road race header, street port center section modifyed to fit the rx3. We hacked off the back flange and welded the 11 gauge pipe up and over the rear end then collected into a single 3 inch Hushpower muffler with a 4 inch dumpy tip... I am VERY happy with it. I tried several other Mufflers out back including the RB rotor shaped one. The Hushpower sounds and looks the best. Really nice deep tone. Its a little louder that the full RB system but it flows way better... I will post pics shortly